- Poddomkratte the car also remove wheels.
- Squeeze out the piston of the brake cylinder, turn out bolts of fastening of a brake support and suspend it on a body (see the Section Removal and installation of brake supports).
|
|
- Remove the air deflector (4), turn out a bolt (5) of fastening of an arm of a cable of the drive of the parking brake, separate the socket of the wheel sensor (6) and release its electrical wiring from the holder.
|
- Turn out nuts of the holder of an electrical wiring of the wheel sensor and a brake tube (8).
|
|
- Turn out the lower bolt (9) of fastening of a rack of a suspension bracket and a bolt (10) of fastening of the lower cross thirst for a rotary fist.
|
- Unhook a returnable spring of a cable of the drive of the parking brake and remove a cable (11).
- Turn out bolts (12 and 13) of fastening of the stabilizer and the top thirst for the longitudinal lever.
|
|
- Turn out bolts of fastening of the longitudinal lever to a body and lower the lever together with a nave and a brake disk.
|
- Turn out from the longitudinal lever a nave with a brake disk.
|
|
- Install special adaptation (16) on the longitudinal lever, turn out a bolt (17) and remove special adaptation and an arm from the lever.
|
- Installation is made upside-down. Use new bolts of fastening of a nave.
|
|
