- Switch off ignition.
|
|
- Remove the lattices of forward loudspeakers (2) fixed on clamps, and remove loudspeakers (3), having disconnected from them an electrical wiring.
|
- Uncover (4), located in the center of the dashboard. On models with ACC and/or the anticreeping alarm system separate the socket, and squeeze out the sensor through an opening in the dashboard.
- Remove a ware box and an air duct (see the Section Removal and installation of the main ware box).
- Establish a steering wheel in provision of the rectilinear movement of the car.
|
|
- Remove caps, turn out 2 screws (7) and remove a safety cushion of the driver.
|
- Separate sockets (8) of a safety cushion, the switch of a horn and audio systems (at the corresponding complete set) – see also Section Removal and installation of assembly of a steering column.
- Give a nut (9) of fastening of a steering wheel, having left it to keep on several rounds of a carving. Shift a steering wheel to a nut, then completely remove a nut and a steering wheel.
|
|
Fix a spiral spring on a steering column. |
|
|
- Turn out 2 screws and remove the diagnostic socket (10).
|
- Remove the left lower section of the dashboard and an air duct (11), having turned out 3 screws.
- Remove illumination of a floor from below of the dashboard.
|
|
- On models remove a cover (13) of the lever of gear shifting from RKPP. On models the small screw-driver shoot the bandage film from AT.
|
- Remove an ashtray with the holder and turn out 2 screws (15) behind it.
- Separate the socket (16) of the switch of the uniform lock and sockets (17) of the lighter and heating of seats.
- Remove casings of a steering column and understeering switches.
- Remove the multipurpose display, the audio system and the control unit of heating and ventilation.
- Uncover at the right end face of the dashboard and the control unit of lighting.
|
|
- Remove the remained switches (7), turn out 6 screws, release 4 clamps (8) and remove the control panel (9).
|
|
|
- Turn out 3 screws and remove the main assembly block (19). Remove a boot (20) steering columns (4 screws).
|
|
|
- Turn out 4 screws and remove a combination of devices, having separated its sockets.
|
- Remove an air duct on the party of the driver (fastens one screw).
- On models with a safety cushion of the forward passenger separate its socket and the holder, having turned out one screw.
- Remove a covering of a threshold of a driver's door, unbend a carpet and remove a protective plate in front of the lower support of the dashboard.
|
|
- Remove back section of the central console, having raised it up and having separated the socket (26).
|
- Install the lever the selector gear shifting / lever in situation "R"/" P" (models with RKPP/AT) and take a key from the ignition lock.
- Remove an immobilizator (28) from the ignition lock, having turned it and having pulled up, and then having separated the socket. Insert a key into the ignition lock.
- Separate the socket of the switch of window regulators (29).
|
|
- Turn out 6 screws (30) of fastening of the top section of the central console and raise its forward part.
|
- Turn out 3 screws and remove a metal bracket (31) with an adjusting pin.
|
|
- Turn out 2 screws and weaken one nut (32) fastenings of the upper edge of the dashboard.
|
- Turn out 2 screws (33) fastenings of bottom edge of the dashboard.
- Remove the dashboard, having raised it and having extended outside.
- Installation is made upside-down.
|
|
