bcee4405

8.5. Replacement of the handle of the lever of gear shifting

Reuse of the removed handle is not allowed.


 PERFORMANCE ORDER

  1. Remove the gear shifting lever (see the Section Adjustment, removal and installation of the drive of gear shifting and the lock of ignition) and clamp it in a vice.
  2. Wind with a tape a neck under the handle, establish on a tape a rozhkovy key on 32 mm and slightly strike it from below with the hammer to bring down the handle with the holder from the lever.
  1. Shoot the film, and then remove the handle from the holder, having pressed the thin screw-driver clamps on the holder.

Pay attention that under the handle the spring is established.

  1. Installation is made upside-down.