bcee4405

10.2.1. Removal, check and installation of assembly of coupling

Removal, check and installation of assembly of coupling

Removal and check

 PERFORMANCE ORDER

  1. Remove RKPP (see the Head the Manual box of gear shifting).
  1. Record a flywheel by means of special adaptation (2), turn out bolts (3) fastenings and remove press a disk from a flywheel.
  1. Examine the flywheel surface interfaced to coupling. Existence of a raid of blue color, and also thin not deep scratches are not the reasons for concern while in the presence of deep scratches the flywheel should be replaced.
  2. Check press a disk for existence of scratches and other damages. If press a disk not equal, it it is necessary to replace.
  3. Strongly worn-out press the disk also should be replaced.
  4. Rotating press the bearing, check it for existence of excessive noise, and also for wear existence. If necessary replace press the bearing.

Installation

 PERFORMANCE ORDER

  1. Establish conducted and press disks on a flywheel and slightly fix them by bolts.

On diesel V6 engines the convex party has to be turned to RKPP.

  1. By means of special adaptation center coupling and tighten bolts of its fastening with the required efforts.

On diesel V6 engines apply the fixing sealant on a carving of bolts.

  1. Remove the device for fixing of a flywheel and establish RKPP.