10.3. Power shafts
Removal and installation of power shafts
|
|
- Poddomkratte the car also remove the corresponding wheel and the left side protection cover. On the diesel V6 models remove the lower protection cover of the engine.
- Remove a cap of a stupichny nut and give it.
- At removal of the right power shaft give fixture of an arm of the sensor of an inclination of headlights (at the corresponding complete set) and take him aside.
- Turn out a bolt of fastening of a spherical support to a rotary fist and lower the suspension bracket lever, having enshrined it in this provision by the wooden whetstone established between the lever and a rack of the stabilizer.
- Weaken a collar of a brake hose and fixture of an electrical wiring of ABS.
- Beat out the external CV JOINT from a nave by means of the hammer with soft brisk. For simplification of removal of a shaft delay a suspension bracket rack.
|
|
Do not damage a shaft vent. |
- At removal of the left power shaft accurately hook the lever the internal CV JOINT and bring him out of transmission.
|
|
At the same time oil will follow from transmission. |
- For removal of the right power shaft beat out it from an intermediate shaft the hammer with soft brisk.
|
|
The internal CV JOINT of the right power shaft on vents has the lock ring established in a flute for fixing with an intermediate shaft. |
- Before installation of the left power shaft replace its epiploon (see the Head the Manual box of gear shifting).
- Be convinced of integrity and correctness of installation of lock rings in their flutes, and also of purity of shlits of the established shaft.
- Establish a shaft in a nave, having delayed a suspension bracket rack.
- Oil vents of the internal end of a shaft gearbox and establish a shaft in transmission / an intermediate shaft to a zashchyolkivaniye of a lock ring.
- Further installation is made as it should be, the return to an order of dismantle of components. Use a new stupichny nut.
|
|
