bcee4405

10.3.3. Removal and installation of an intermediate shaft and its bearing

The description for 4-cylinder petrol engines is given below. Removal and installation of an intermediate shaft and its bearing on models with other engines is made similarly. On the petrol V6 models in addition it will be required to remove a sleeve of cooling of the generator, and on the diesel V6 models – side and the lower protection covers of a motive compartment.


 PERFORMANCE ORDER

  1. Cover wings with protective covers and disconnect a negative wire from the battery.
  2. Poddomkratte the car also remove the right forward wheel.

4-cylinder engines

 PERFORMANCE ORDER

  1. Uncover a belt of the drive of auxiliary units.
  1. Remove the top cover of the engine and a collar of a tube of GUR.
  2. Insert a wedge between the pallet of a case of the engine and a stretcher and remove the top arm of the engine.
  3. By means of special adaptation squeeze a natyazhitel of a belt of the drive of auxiliary units and take off a belt. Remove a natyazhitel (see the Head Dvigatel).
  4. Turn out the top bolt of fastening of the generator (see the Head Sistemy of electric equipment of the engine).
  1. Weaken a collar of a brake hose and fixture of an electrical wiring of ABS (10).
  1. Turn out a bolt (1) of fastening of the lever of a suspension bracket to a rotary fist and beat out the hammer with soft brisk a power shaft from an intermediate shaft (12).
  2. Lower the lever of a suspension bracket and enshrine it in this provision by means of wooden whetstone, having established it between the lever and a rack of the stabilizer of a suspension bracket.
  3. Turn a wheel for ensuring the best access to a power shaft to the left and beat out it further away if it is necessary. Then pull for a rack of a suspension bracket and lower a power shaft on the suspension bracket lever.
  4. Give nuts of fastening of an electrical wiring of the generator and turn out the lower bolt of its fastening. Remove the generator aside.
  5. Turn out bolts (20 and 15) of fastening of an arm of the bearing of an intermediate shaft (21 and 16), remove an arm from guides and take an intermediate shaft from transmission.
Fixture of an arm of the bearing of an intermediate shaft on petrol models.
Fixture of an arm of the bearing of an intermediate shaft on diesel models.

At the same time oil will follow from transmission.

  1. Replace an epiploon of an intermediate shaft in transmission (see the Head the Manual box of gear shifting).
  2. In need of replacement of the bearing fix a shaft in a vice and remove a small lock ring.
Replacement of the bearing of an intermediate shaft on petrol models.

On diesel models remove the holder of the bearing and a lock ring.


Replacement of the bearing of an intermediate shaft on diesel models.
  1. By means of special adaptation to a vypressuyta a shaft from the bearing, remove a big lock ring (only on petrol models) and a vypressuyta the bearing from an arm.
  2. Installation is made upside-down. Before installation of a shaft in transmission be convinced that it is pure.