12.2.2. Removal, dismantling assembly and installation of a rack of a suspension bracket


  1. Remove a forward wheel.
  1. Disconnect a rack of the stabilizer (3) from the shock-absorber.
  1. Give two lower nuts (4) fastenings of a rack to a rotary fist and remove the holder of an electrical wiring of the wheel sensor and a brake hose aside.
  2. Separate a rotary fist from a rack.
  1. Give three top bolts of fastening of a rack and remove assembly of a rack of a forward suspension bracket.
  1. Clamp a rack in a vice and by means of special adaptation squeeze a spring.
  1. Holding the shock-absorber from a provorachivaniye, give a lock-nut on its rod.

Reuse of a nut of fastening of a spring is not allowed.

  1. Remove the bearing and the top saddle of a spring (3), and also a spring, a rubber casing and the limiter of compression (4).
  1. Assembly and installation are made upside-down. Pay attention to that the spring rested against a stopper on its lower saddle.