- Uncover the inlet pipeline. On the V6 models give nuts from a flange of an exhaust pipe.
|
|
- Turn out bolts of fastening of a back pillow of the engine to a stretcher.
|
- Disconnect a transmission support from a stretcher. On the V6 models establish 2 lifting eyes: one on a back part of a head of cylinders, another – to the place of a bolt on a forward part of a head of cylinders.
- Install the elevator on wings and you will hang out the engine.
- Separate electrical wiring sockets a lambda probe(s) and remove its collars.
- Remove forward wheels and the lower protection covers of a motive compartment.
|
|
- Give oil cooler fixture, having left it to hang on hoses. Fasten with a plait assembly of a radiator to its support.
|
|
|
- Remove the amplifier (11) from a back part of a stretcher, at the corresponding complete set remove the sensor of temperature from the catalytic converter and lower forward section of an exhaust pipe (12).
|
- Turn out two bolts of fastening of the steering mechanism (13).
|
|
- Disconnect from a stretcher levers of a suspension bracket (14) and the stabilizer of cross stability (15).
|
- Give nuts of fastening of the air cleaner to a stretcher.
- Remove a back collar of a tube of GUR and an arm from a stretcher. Also release tubes To/in from their holders.
- Prop up a stretcher and turn out the remained bolts of its fastening (see
the illustration Fixture of Components of a Forward Suspension Bracket and Steering).
- Slightly lower a stretcher so to provide access to not removed collars of tubes of GUR.
|
|
- Lower a stretcher and remove arms (20) of fastening of assembly of a radiator and holders (21) of tubes К/В.
|
- Installation is made upside-down. Tighten fixture with the required efforts.
|
|
