- Tire out the car on the elevator, and cover wings with protective covers.
- Remove an inlet air duct and the top cover of the engine.
- Turn out a bolt of a back support of the engine and you will hang out the engine.
- Lift the car and remove forward wheels. Remove the lower protection covers of a motive compartment.
|
|
- On models with xenon headlights remove the loading sensor from an arm and take him aside.
|
- Remove side protection covers of wheel arches and intermediate section of an exhaust pipe.
|
|
- Disconnect a support of the engine and levers of a suspension bracket from a stretcher.
|
- Remove the stabilizer of cross stability from a stretcher.
- Remove the air cleaner and the lower protection cover of a radiator from a stretcher.
- Fasten with a plait a radiator to its support and remove rubber holders of tubes of cooling of GUR.
|
|
- Turn out bolts of fastening of amplifiers of a stretcher (19), disconnect a sleeve of cooling of the accumulator, prop up a stretcher and turn out the remained bolts of its fastening (22).
|
|
|
Average bolts of fastening of a stretcher differ from other bolts and at installation have to be rolled on former places. |
- Remove a support of a tube of the intercooler and lower a stretcher so that it was possible to turn out bolts of fastening of the steering mechanism.
- Release from holders of a tube of GUR and K/V and remove a stretcher.
- Installation is made upside-down. Tighten fixture with the required efforts.
|
|
