bcee4405

3.23. AT liquid replacement

 PERFORMANCE ORDER

  1. Tire out the car on the elevator, install the AT selector lever in situation "P" and cock the parking brake.
  1. Substitute under a drain stopper of AT capacity for collecting liquid. Turn out a stopper and lower ATF.

When replacing ATF previously it is necessary to warm it therefore be attentive and do not burn a hand with the following liquid.

  1. Tighten a stopper with a new sealing ring.
  2. Disconnect from AT a final hose and its zakuporta.
  3. Connect to the AT outlet the device for washing and lower the car on the earth.
  4. Fill in AT 4 l of liquid according to requirements (see the Section Check of Levels of Liquids, control of leaks).
  5. Lower the end of a hose in a measured vessel with a capacity not less than 2 l and start the engine. At the lever of the AT selector which is in situation "P" lower 2 l of old ATF then kill the engine.
  6. Fill 2 l of fresh ATF in AT. Start the engine.
  7. At the lever of the AT selector which is in situation "P" lower 1 l of old ATF then kill the engine.
  8. The car also establish to Poddomkratta it on props.
  9. Remove a hose of the device of washing and connect to AT a final hose with new consolidations. Fix a hose with effort of 27 N • m.
  10. Lower the car on the earth.
  11. Cock the parking brake, squeeze out a pedal of a brake and start the engine.
  12. Warm up ATF up to the temperature of 80 a hail.
  13. Check and if necessary modify the ATF level (see the Section Check of Levels of Liquids, control of leaks).