bcee4405

4.5.4. Replacement of epiploons of a bent shaft

 PERFORMANCE ORDER

  1. Bring the piston of the first cylinder into the provision of VMT of the end of a step of compression (see the Section Reduction of the Piston of the First Cylinder in the provision of VMT and replacement of a belt of the drive of auxiliary units and its natyazhitel).
  2. Give fixture tension and adjusting rollers (see the Section Removal and installation of the inlet pipeline, a belt of the GRM drive and heads of cylinders).
  3. Mark the direction of the movement of a belt of the GRM drive, and also its situation concerning cogwheels.
  4. Remove KM-800-10 adaptation from a bent shaft, having left the fixing devices on camshafts.
  5. Shoot the lower adjusting video and the washer located behind it. Take off a GRM drive belt.
  6. Turn a bent shaft in situation 60 a hail. to VMT and a poddomkratta the car.
  1. Holding a cogwheel of a bent shaft by means of special adaptation, give its fixture and remove a cogwheel together with a pro-rate (19 on an illustration).
  1. Accurately take an epiploon (20 on an illustration), trying not to damage the interfaced surface.
  2. Grease a new epiploon, establish it on a bent shaft and press by means of special adaptation or a piece of a pipe of suitable diameter.
  3. Establish a pro-rate and a cogwheel of a bent shaft. Lower the car on the earth.
  4. Establish a belt of the GRM drive and adjust its tension as it is described in the Section Removal and installation of the inlet pipeline, a belt of the GRM drive and heads of cylinders.
  5. Further installation is made as it should be, the return the sequence of dismantle of components.

Back epiploon

 PERFORMANCE ORDER

  1. Depending on a complete set remove RKPP/AT and a flywheel / a driving disk (see the Head the Manual box of gear shifting or Automatic transmission).
  2. Accurately take an epiploon (3 on an illustration).
Removal (3) and installation (5) of a back epiploon.

Damage of the interfaced surface of the block of cylinders is not allowed.

  1. Oil motive sealing edges of a new epiploon and press it into place by means of special devices (5 on an illustration).
  2. Establish a flywheel / a driving disk and RKPP/AT (depending on a complete set).