- Separate the electrical wiring socket a lambda probe (1 on an illustration) and cut the cable coupler holding it. Remember a route of laying of an electrical wiring and take away it down. Give two top nuts of fastening of forward section of an exhaust pipe to a turbocompressor.
|
|
Socket (1) lambda probe and section of the protection cover (3).
|
- The car also establish to Poddomkratta it on props. Remove the lower back section of the protection cover of the engine (3 on an illustration).
- Remove forward section of an exhaust pipe.
|
|
- Lower motive oil (5 on an illustration), give bolts of fastening of the pallet of a case (6) and remove it.
|
- Remove a maslozabornik (7 on an illustration) with a sealing ring and a maslootrazhatelny plate (8).
- Installation is made upside-down. Previously clear the interfaced surfaces. If the sealing ring of a maslozabornik is damaged, use new. Apply the fixing sealant on a carving of bolts of fastening of a maslootrazhatelny plate, a maslozabornik and the pallet of a case. Tighten fixture with the required efforts.
|
|
