Saab:: 9-5: Removal and installation of assembly of the lever of the selector of the AT modes and its casing

1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting
9. Automatic transmission
- 9.1. General information
- 9.2. Search of malfunctions - the general information
- 9.3. Removal and installation of assembly of the lever of the selector of the AT modes and its casing
- 9.4. Removal, installation and adjustment of a cable of the selector of the AT modes
- 9.5. Removal and installation of the lever of the selector of the AT modes and dismantling of its casing
- 9.6. Removal and installation Ý/m AT valves, their case and its cover
- 9.7. Removal and installation of sensors of speed
- 9.8. Removal and installation of the AT hydraulic lines
- 9.9. Removal and TCM installation
- 9.10. Replacement and adjustment of the sensor of position of the selector of the AT modes
- 9.11. Removal and AT installation
- 9.12. Replacement of epiploons of power shafts
10. Coupling and power shafts
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment

9.3. Removal and installation of assembly of the lever of the selector of the AT modes and its casing

PERFORMANCE ORDER

Remove the central and lower consoles of the dashboard, and also an air duct of back deflectors (see the Head Kuzov).

Remove a lock ring and an antinoise clamp (2).

Take away a finger (3) and remove a cable tip from a ball.
Turn out screws (4) fastenings of a casing and separate the socket (5).
Raise a casing, cut couplers of an electrical wiring of the lock of ignition and a safety cushion then separate the socket (6) of the lock of ignition.

Remove the bracket (7) located behind a clamp (8) and, having accurately squeezed his uvulas, release a cable from the holder.

Remove a casing with the selector lever.
Installation is made upside-down.
In conclusion of installation adjust a selector cable (see the Section Removal, installation and adjustment of a cable of the selector of the AT modes).