bcee4405

9.4. Removal, installation and adjustment of a cable of the selector of the AT modes

 PERFORMANCE ORDER

  1. Remove the rechargeable battery together with the pallet.
  1. Establish AT in situation "1" and remove an arm (2) selectors about AT, a clip (3) from a bracket of a cable and a cable (4) from a bracket.
  1. The subsequent removal of a cable is carried out during removal of assembly of the lever of the selector with its casing (see the Section Removal and installation of assembly of the lever of the selector of the AT modes and its casing).
  2. Extend a cable and rubber consolidation in interior of the car.
  3. Installation is made upside-down. For simplification of installation of rubber consolidation grease it with vaseline. In conclusion of installation adjust a selector cable.

Check and adjustment

 PERFORMANCE ORDER

  1. Adjustment of a cable of the selector of the AT modes is required if the selector lever course in provisions "D" and "N" different.
  1. Install the selector lever in situation "P" and lift an adjusting clamp.
  1. Move the lever on AT to situation "P" and drive the car before inclusion of blocking of the lever of the selector in situation "P".
  2. Pull the lever on AT back to choose a side play and, holding the lever in this situation, press an adjustment clamp.
  3. Make sure that the selector lever course identical in provisions "D" and "N".