5.2.4. Removal and installation of the fan of a heater


  1. Switch off the mode of circulation and switch off ignition.
  2. Remove levers of screen wipers and rubber consolidations from their spindles.
  3. Disconnect its consolidation from the center of a partition of a motive compartment.

Do not remove side clamps.

  1. Remove a windshield fairing. For a fairing detachment from glass pull a fairing forward.
  2. Release the water filter from clamps and remove it.
  3. Turn out 4 bolts of fastening of the mechanism of screen wipers and remove it, having separated the socket.
  1. Give 2 nuts at forward edge of a frame round the heater fan, release it from two clamps and remove it (9 on an illustration).
  1. Turn out 3 bolts and remove the arm of levers of screen wipers (10 on an illustration) located over the heater fan.
  1. Disconnect an electrical wiring plait from a fan cover (11 on an illustration), turn out 4 bolts and uncover (12).
  1. Raise the heater fan, separate its socket and cut cable couplers of its electrical wiring (13 on an illustration).
  2. Extend the fan sideways.
  3. Installation is made upside-down.