bcee4405

13.1.12. Removal, dismantling, assembly and installation of a door of a back and its components

Removal, installation and adjustment of a door

 PERFORMANCE ORDER

  1. Open a door of a back and remove casings from its loops.
  1. Remove the top cover of glass, a covering of a rack of D and a ceiling, holders of a grid for fixing of freights, and also clamps and covers between racks of C and D.
  1. Start up a covering of a ceiling a little and separate sockets of an electrical wiring and tube of windscreen washer (5). On both parties reveal cable channels (6) and remove them from electrical wiring plaits.
  1. Remove an electrical wiring through loops (7), ask the assistant to hold a door and turn out 4 bolts (9) of its fastening to loops.
  1. Remove a door from loops.
  2. Installation is made upside-down. After installation adjust the provision of a door concerning a body.
  3. Adjustment of provision of a door in to the left-to the right is also back and forth made at the released bolts (9) of fastening of a door to loops. For adjustment of provision of a door perform the operations described below up-down.
  1. Remove a side emphasis, consolidation and finishing of a doorway.
  1. Remove the components specified in paragraph 2 and slightly lower a ceiling covering.
  1. Adjust the provision of a door, having released 3 bolts on each loop (8).
  1. Tighten bolts and install the being removed components.

Internal handle and covering of a door

 PERFORMANCE ORDER

  1. Open a back door.
  1. Remove a frame (2) around the internal handle, having unbent it the screw-driver in three 3 cuts, and having pulled down at the released clamps.
  1. Release a door covering from clamps (3).
  1. Remove a covering. For this purpose at first pull it the top part down, and then pull back.
  1. Remove two drafts of the lock (5), turn out screws (6), shift the handle aside and remove it (7).

Lock and cylinder of the lock

 PERFORMANCE ORDER

  1. For removal of the cylinder of the lock give nuts, unhook draft (5) and separate the socket.
  1. For removal of the lock disconnect 3 drafts (5), turn out 4 bolts (6) and separate the socket (7).

External handle

 PERFORMANCE ORDER

  1. Turn out screws outside of a door.
  1. Remove both back combined a lamp and a plate of registration plate (6).
  1. Turn out nuts (7), remove draft and separate the socket (7).
  1. Release clamps and remove the lock together with illumination of registration plate.