bcee4405

13.1.13. Removal and installation of a trunk lid and its components

Trunk lid

 PERFORMANCE ORDER

  1. Open a trunk lid and separate the socket under a cover in a covering before the left combined lamp (2).
  1. Disconnect a hose (3) from a body, and then from a loop.
  1. Remove a clamp (4) fastenings drains to the hinge and disconnect a rack (5) from a loop.
  1. Give 2 lower nuts (6) of fastening of a trunk lid to loops, then on several turns give two top nuts (7) and remove a trunk lid.
  2. Installation is made upside-down. After installation adjust the provision of a door concerning a body.
  1. It is possible to displace a trunk lid back and forth at the released nuts.
  1. Adjustment of a trunk lid on height is made at the released screws of fastening of its loops to a body. It is possible to adjust separately height of the forward party of a trunk lid (at the released forward screws).
  1. Height of the back party of a trunk lid is regulated by means of rotation of rubber support.

External handle

 PERFORMANCE ORDER

  1. Remove a plate of registration plate and open a trunk lid.
  1. Give nuts of fastening of the decorative panel and remove it.
  1. Give nuts, squeeze clamps and remove the left combined lamp.
  1. Give 4 nuts (5) of fastening of the handle, slightly delay it, separate the socket of an electrical wiring (7) and remove the handle.
  1. Installation is made upside-down.

Lock

 PERFORMANCE ORDER

  1. Remove the internal handle and a covering from within a luggage carrier (1). Turn out 3 screws of fastening of the lock (2).
  1. Turn a clamp (3) rods of the drive of the lock and disconnect a rod. Remove a rod and the lock (4).
  1. When replacing the lock transfer a rod to the new lock.

Э / lock drive motor

 PERFORMANCE ORDER

  1. Remove the internal handle and a covering from within a luggage carrier (1).
  2. Turn a clamp (3) rods of the drive of the lock and disconnect a rod.
  1. Take the central pin of fastening of the mechanism of the drive of the lock and remove the mechanism, having left it to hang on draft.
  1. Turn out fastening screws э / the motor, separate the socket (5) and remove э / the motor (6).
  2. Installation is made upside-down.