bcee4405

6.3.14. Removal and installation of the fuel distributive highway and injectors

During the work with the fuel distributive highway and injectors observe exclusive purity.


 PERFORMANCE ORDER

  1. Remove the top cover of the engine.
  2. At the working engine take a safety lock No. 19 and after a stop of the engine turn the ignition key in the provision of "OFF".

4-cylinder engines of 2.3 l

 PERFORMANCE ORDER

  1. Remove a hose of ventilation of a case (3 on an illustration), remove the probe of level of motive oil with a cover of a maslozalivny mouth (4).
  1. Remove the protection cover and disconnect a cable of the drive of a butterfly valve (5 on an illustration).
  1. Separate sockets of injectors, the module of ignition, the sensor of absolute pressure, the MAF sensor and the sensor of pressure of pressurization (6 on an illustration).
  1. Weaken the top bolt (7 on an illustration) the holder of an electrical wiring, then the lower bolts (8) then raise the holder and shift it (9) back.
  2. Weaken connections of fuel lines (11 on an illustration) and clear area around injectors compressed air.
  1. Disconnect a vacuum hose of the regulator of pressure of fuel (13 on an illustration) and turn out 2 bolts of fastening of the fuel distributive highway.
  1. Accurately separate the fuel distributive highway, having raised it by means of two wedges, and then remove finally.
  2. Installation is made upside-down. Grease sealing rings of injectors with acid-free vaseline. After installation adjust a cable of the drive of a butterfly valve (see the Section Removal and installation of drop of gas, adjustment of a cable of the drive of a butterfly valve).

4-cylinder engines of 2.0 l

 PERFORMANCE ORDER

  1. Remove a hose of ventilation of a case (3 on an illustration), remove the probe of level of motive oil with a cover of a maslozalivny mouth (4).
  1. Disconnect a cable of the drive of a butterfly valve together with his holder.
  2. Turn out a bolt of fastening of the giving turbocompressor tube to a head of cylinders, weaken collars and pick up the phone.
  3. Turn out the top forward bolt of fastening of the holder of an electrical wiring about a lifting eye of the engine, then turn out a back bolt, lift the holder and shift it back.
  1. Separate sockets of injectors, the module of ignition, the sensor of absolute pressure, the control valve of pressure of pressurization and the sensor of pressure of pressurization.
  1. Release an electrical wiring from couplers and clamps and shift it aside.
  2. Clear area around injectors compressed air.
  3. Act according to item 6-8 (4-cylinder engines of 2.3 l).

6-cylinder engines

 PERFORMANCE ORDER

  1. Disconnect the giving hose (3 on an illustration) a turbocompressor, and also a driving cable (4) from the throttle case then disconnect it from the inlet pipeline and accurately shift aside.
  1. Remove the top section of the inlet pipeline and a zakuporta open channels to prevent hit of dirt in them (5 on an illustration).
  1. Disconnect from the fuel distributive highway an electrical wiring (6 on an illustration), remove fuel lines (7) and disconnect a vacuum hose of the regulator of pressure of fuel (8).
  2. Clear area around injectors compressed air, turn out bolts of fastening of the fuel distributive highway and remove it together with injectors.
  3. Installation is made upside-down. Grease sealing rings of injectors with acid-free vaseline. After installation adjust a cable of the drive of a butterfly valve (see the Section Removal and installation of drop of gas, adjustment of a cable of the drive of a butterfly valve).