bcee4405

6.4.12. Removal and installation of the sensor of a reserve of fuel

 PERFORMANCE ORDER

  1. Install the car on the flat platform, lift a pillow of a back seat and unbend a sexual covering.
  1. Uncover (2 on an illustration) the fuel reserve sensor, separate its socket (3) and cut a cable coupler.
  1. Disconnect two contacts from the brown socket (4 on an illustration).
  2. Accurately disconnect control valves and fuel lines from the fuel tank, previously having marked their situation not to mix at installation.
  3. Turn out a screw ring.
  4. Raise fuel capacity assembled with the fuel reserve sensor so that its top part towered approximately on 5 cm over the fuel tank then turn assembly clockwise to an arrow on a corner approximately on the 80th hail. also remove it from a tank.

Prepare for an effluence of a small amount of fuel.

  1. Clear the interfaced surfaces and establish a new sealing ring in a groove of the fuel tank.
  2. Further installation is made upside-down. If necessary replace sealing rings of connections of fuel hoses with the pump.