bcee4405

4.4.5. Replacement of a belt of the drive of auxiliary units

Check of a state and tension of a belt of the drive of auxiliary units is described in the Section Check of a State and Tension of a Belt of the Drive of Auxiliary Units.

Removal of components in the right part of a motive compartment

2 — GUR Tube
3 — Klin
4 — the Right support of the engine

5 — the MAF Sensor
6 — the Right support of the engine
7 — the Lifting eye of the engine


 PERFORMANCE ORDER

  1. Uncover the inlet pipeline.
  2. The car also establish to Poddomkratta it on props and turn the right forward wheel outside then pick up the pump GUR phone from a frame (2 on an illustration).
  3. Establish a wedge between the pallet of a case and a frame (3 on an illustration).
  4. Remove a rubber saddle of the MAF sensor (5 on an illustration) and take him aside.
  5. Remove the right support (4 on an illustration) the engine together with a collar.
  6. Unload a natyazhitel of a belt and record it in this situation, having inserted a prutkovy key (3 mm) into its opening.
  7. Take off a driving belt from pulleys.
  8. Installation is made upside-down.