bcee4405

4.4.8. Removal and installation of the pallet of a case

Removal of forward section of an exhaust pipe


 PERFORMANCE ORDER

  1. Remove a decorative cover of the engine, take the probe of level of motive oil and stop up its guide with rags.
  2. Disconnect an electrical wiring from a lambda probes, disconnect a perepuskny tube of a turbocompressor and remove the thermofilter over a final collector.
  3. Give 2 top nuts on an exhaust pipe (4 on an illustration). Poddomkratte the car also remove the lower protection cover of the engine. Then give the remained fixture (6) and remove forward section of an exhaust pipe.
  1. Remove the protection cover from transmission (7 on an illustration). Lower motive oil and disconnect a hose of a sapun of a case (9 on an illustration) from the case pallet.
  1. Give bolts of fastening of the pallet of a case and remove it.

On models with the B235R and RKPP engine for access to the hidden bolts of fastening of the pallet of a case drill openings or beat out traffic jams (depending on a year of release) in the places specified illustrations A. The pallet is removed by means of the lever with the pointed end (see an illustration B).

A

The provision of openings or traffic jams for access to the hidden bolts.

B

Separation of the pallet of a case from the block of cylinders of the B235R engine.
  1. If the pallet of a case is removed for the purpose of replacement, rearrange a maslootrazhatelny plate and a tube on the new pallet. At the same time use new sealing rings.
  2. Make sure of lack of dirt in the pallet. Clear the pallet of a case and the block of cylinders of old pro-masonry material. Apply a pillow of sealant 2 mm thick on the interfaced surface of the pallet of a case.
  3. Check that the bringing tube is correctly established on the place.
  4. Installation is made upside-down. After installation warm up the engine and make sure of lack of leaks via the case pallet. If necessary modify the level of motive oil.