bcee4405

4.4.6. Replacement of epiploons and pulley of a bent shaft

 PERFORMANCE ORDER

  1. The car also establish to Poddomkratta it on props. Remove the right forward wheel.
  2. Take off a belt of the drive of auxiliary units (see the Section Replacement of a Belt of the Drive of Auxiliary Units).
  1. Remove the lower cover of a flywheel and block rotation of a flywheel by means of special adaptation.
  1. Turn out a bolt of fastening of a pulley of a bent shaft (6) and accurately take the screw-driver an old epiploon (7).

Do not damage the surface of the oil pump interfaced to an epiploon.

  1. Establish a new epiploon by means of special adaptation or a piece of a pipe of suitable diameter.
  2. Further installation is made as it should be, the return the sequence of dismantle of components. In conclusion start the engine, let's it work idling. Kill the engine and check existence of leaks through an epiploon.

Back epiploon

 PERFORMANCE ORDER

  1. Remove RKPP or AT, depending on model (see the Head the Manual box of gear shifting or Automatic transmission). On models remove coupling and a persistent plate from RKPP (see the Head Stsepleniye and power shafts).
  2. Remove a flywheel or a driving disk.
  3. Accurately take the screw-driver an old epiploon.

Do not damage the surface interfaced to an epiploon.


  1. Press a new epiploon by means of the special adaptation (1 on an illustration) installed on cranked to a shaft.
  1. Installation is made upside-down. Tighten fixture with the required efforts.